ELITE
ELITE.12d4/d2
OWNER’S MANUAL
Subwoofer Owner’s Manual
LED WIRING
SMALL TERMINAL: LEDs
(+12v and Ground Only)
The Elite.12 has three terminals. The two larger terminals are
connected to the voice coils. The small terminal is used to
power the LEDs with a +12v and ground connection only.
DO NOT CONNECT AN AMPLIFIER’S SPEAKER OUTPUT TO THE
LED TERMINAL. It will damage the LEDs, this is not covered by
warranty. Only use +12v and ground to power the LEDs.
LARGE TERMINAL:
VOICE COIL
Specifications
FEATURES:
• 60mm of Peak to Peak Excursion
• Dual 4 and 2 Ohms Voice Coils
• 3.0”Premium OFC Copper Wound Voice Coil
• Dual Long Throw Spider Suspension
• Woven Tinsel Leads
T/S Parameters:
Re (Dcr)
FS (Hz)
Elite.12d4
Elite.12d2
1.7
31
1.0
30
Sd (SqM)
BL TM
.05
.05
14.4
3.23
.49
12.2
3.5
Qms
• Composite Material Hybrid Cone
Qes
.57
• High Excursion CAE/CAD Motor Design
• Vented Titanium-Aluminum Hybrid Former
• One Piece Aluminum Plated Dustcap with Tri-Blue LEDs
• High Roll Butyl Rubber Surround
• Nickel Plated 12 Gauge Speaker Terminal
• Optimized for Sealed or Vented Enclosures
• Rigid Powder Coated Anti-Resonant Castbasket
Qts
.42
.49
Vas (liters)
Cms (uM/N)
Mms (gms)
Impedance
31.1
85
20.5
60
300
Dual 4
428
Dual 2
*Specifications subject to change
**Parameters are AFTER break in. Elite.12 does not require any special break in procedure.
One to two weeks of normal use will naturally break in the suspension of the driver.
Specifications:
Elite.12d4/2
1600 watts
Power Handling Note:
The Elite.12’s recommended power range is 1200 to 1600 watts
RMS for normal use. Driving the woofer with significantly higher RMS
power will cause thermal failures (burnt voice coils) and will have no
audible increase in output. A subsonic filter is also required when
using a vented enclosure as it will increase reliability and perfomance
drastically.
RMS Power Handling
Xmax (Peak to Peak)
Mounting Diameter
Mounting Depth
60mm
11 5/16in - 287mm
7 1/8in - 180mm
Phoenix Gold
A Division of AAMP of America™
13190 56th Court
Clearwater, Florida 33760
P: 866-788-4237
© 2013 AAMP of Florida, Inc
Designed and Engineered in the USA
LIMITED WARRANTY
Phoenix Gold warrants this product to be free of defects in materials and workmanship for a period of one (1) year from the original date of purchase. This
warranty is not transferable and applies only to the original purchaser from an authorized Phoenix Gold dealer in the United States of America only. Should
service be necessary under this warranty for any reason due to manufacturing defect or malfunction, Phoenix Gold will (at its discretion), repair or replace the
defective product with new or remanufactured product at no charge. Damage caused by the following is not covered under warranty: accident, misuse, abuse,
product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not
cover incidental or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear
and tear is not covered under warranty.
INTERNATIONAL WARRANTIES
Products purchased outside the United States of America are covered only by that country’s Authorized Phoenix Gold reseller and not by Phoenix Gold.
Consumers needing service or warranty information for these products must contact that country’s reseller for information.
|