Nokia Bluetooth Headset BH-304
6
9
7
8
10
11
6
11
12
11
6
Issue 1
Introduction
The Nokia Bluetooth Headset BH-
device and the headset do not need
304 allows you to make and receive to be in line of sight, but they should
calls while on the move. You can use be within 10 meters (33 feet) of each
the headset with compatible devices other. Connections may be subject to
that support Bluetooth wireless
technology.
interference from obstructions, such
as walls, or other electronic devices.
Read this user guide carefully before The headset complies with the
using the headset. Also read the user Bluetooth Specification 2.0 + EDR
guide for your mobile device, which that supports the Headset Profile 1.1
provides important safety and
and Hands-Free Profile 1.5. Check
maintenance information. Keep the with the manufacturers of other
headset and its accessories out of
reach of small children.
devices to determine their
compatibility with this device.
There may be restrictions on using
Bluetooth technology in some
locations. Check with your local
authorities or service provider.
Bluetooth wireless technology
Bluetooth wireless technology
allows you to connect compatible
devices without cables. The mobile
Get started
The headset contains the following
parts shown on the title page:
(3), charger connector (4),
microphone (5), volume key (6),
earloop (1), earpiece (2), power key
3
indicator light (7), and answer/end
key (8).
Charge the battery
The headset has an internal,
nonremovable, rechargeable battery.
Do not attempt to remove the
battery from the device, as you may
damage the device.
Before using the headset, you must
charge the battery and pair the
headset with a compatible device.
Parts of the headset are magnetic.
Metallic materials may be attracted to
the headset. Do not place credit cards
or other magnetic storage media near
the headset, because information
stored on them may be erased.
1. Connect the charger to a wall
outlet.
2. Connect the charger cable to the
charger connector. The red
indicator light is on while
charging. It may take a while
before charging starts. If
Chargers
Check the model number of any charger
before using it with this headset. The
headset is intended for use with the
AC-3, AC-4, and DC-4 chargers.
charging does not start,
disconnect the charger, plug it in
again, and retry. Charging the
battery fully may take up to 1
hour and 30 minutes.
Warning: Use only chargers
approved by Nokia for use
with this particular
3. When the battery is fully charged,
the indicator light turns to green.
Disconnect the charger from the
headset and the wall outlet.
enhancement. The use of any other
types may invalidate any approval or
warranty and may be dangerous.
When you disconnect the power cord of
any enhancement, grasp and pull the
plug, not the cord.
The fully charged battery has power
for up to 6 hours and 30 minutes of
talk time or up to 150 hours of
4
standby time. However, the talk and 3. Activate the Bluetooth feature on
standby times may vary when used
with different compatible Bluetooth
devices, usage settings, usage styles,
and environments.
the mobile device, and set the
device to search for Bluetooth
devices.
4. Select the headset from the list of
found devices.
When battery power falls low, the
headset beeps, and the red indicator
light starts to flash.
5. Enter the passcode 0000 to pair
and connect the headset to your
device. In some devices you may
need to make the connection
separately after pairing. You only
need to pair the headset with
your device once.
Switch the headset on or off
To switch on, press and hold the
power key until the headset beeps
and the green indicator light is
displayed.
If the pairing is successful, the
To switch off, press and hold the
power key until the headset beeps
and the red indicator light is
displayed briefly.
headset beeps and appears in the
device menu where you can view the
currently paired Bluetooth devices.
Pair the headset
1. Ensure that your mobile device is
switched on and the headset is
switched off.
2. Press and hold the power key
until the green indicator light
starts to flash quickly.
5
Basic use
answer/end key twice while no call is
in progress.
Place the headset on the ear
The headset is ready to be used on
your right ear. Slide the earloop over
your ear (9), and point the headset
toward your mouth (10). To use the
headset on the left ear, rotate the
earloop so that the loop is to the left
of the "Nokia" logo (11).
If your device supports voice dialing
with the headset, press and hold the
answer/end key when no call in
progress, and proceed as described
in the user guide of your device.
To answer or end a call, press the
answer/end key. To reject an
incoming call, press the answer/end
key twice.
Change the cover
The headset may be supplied with
front covers in different colors. To
change the cover, pull the current
cover starting from the top (12), and
push the new cover into place.
To adjust the headset volume, press
the volume key up or down.
To mute or unmute the microphone,
press the middle of the volume key.
Call handling
To make a call, use your mobile
device in the normal way when the
headset is connected to the device.
To switch the call between the
headset and a compatible device,
press and hold the answer/end key.
Clear settings or reset
To clear all the pairing settings from
the headset, switch off the headset,
If your device supports last number
redialing with the headset, press the
6
and press and hold the power key
To reset the headset if it stops
and the answer/end key until the red functioning, although it is charged,
and green indicator lights start to
alternate.
plug the headset into a charger, and
press the power key and the answer/
end key at the same time.
Battery information
Your device is powered by a
rechargeable battery. The battery can
Always try to keep the battery between
15°C and 25°C (59°F and 77°F). A device
be charged and discharged hundreds of with a hot or cold battery may not work
times, but it will eventually wear out. temporarily, even when the battery is
Recharge your battery only with Nokia fully charged. Battery performance is
approved chargers designated for this
device.
particularly limited in temperatures
well below freezing.
Unplug the charger from the electrical Do not dispose of batteries in a fire as
plug and the device when not in use. Do they may explode. Batteries may also
not leave a fully charged battery
connected to a charger, since
explode if damaged.
overcharging may shorten its lifetime.
If left unused, a fully charged battery
will lose its charge over time.
Never use any charger that is damaged.
Leaving the device in hot or cold places,
such as in a closed car in summer or
winter conditions, will reduce the
capacity and lifetime of the battery.
7
Care and maintenance
Your device is a product of superior
design and craftsmanship and should
be treated with care. The following
suggestions will help you protect your
warranty coverage.
•
•
Do not attempt to open the device.
Do not drop, knock, or shake the
device. Rough handling can break
internal circuit boards and fine
mechanics.
•
Keep the device dry. Precipitation,
humidity, and all types of liquids or
moisture can contain minerals that
will corrode electronic circuits. If
your device does get wet, allow it to
dry completely.
•
•
Do not use harsh chemicals,
cleaning solvents, or strong
detergents to clean the device.
Do not paint the device. Paint can
clog the moving parts and prevent
proper operation.
•
•
Do not use or store the device in
dusty, dirty areas. Its moving parts
and electronic components can be
damaged.
All of the above suggestions apply
equally to your device, battery, charger,
or any enhancement. If any device is
not working properly, take it to the
nearest authorized service facility for
service.
Do not store the device in hot areas.
High temperatures can shorten the
life of electronic devices, damage
batteries, and warp or melt certain
plastics.
•
Do not store the device in cold
areas. When the device returns to its
normal temperature, moisture can
form inside the device and damage
electronic circuit boards.
8
|