LCD16DX
INSTRUCTION MANUAL
EQ
RDM
RPT
LOC
INT
MUTE
LUD
CLK
AUTO-LOADING COMPACT DISC PLAYER
AM/FM-STEREO MANUAL TUNING RADIO
BASIC OPERATION
7. MON/INT BUTTON
MON MODE: Press it to select mono or stereo mode.
INT MODE: During CD mode, press INT (intro) button to hear the first 10 seconds
of each track on the disc. Press this button again to restore the player to its normal
play mode.
8. LOC/RPT BUTTON
LOCAL/DISTANCE MODE: When in the radio mode, press it to select local or
distance broadcast station receive sensitivity.
REPEAT MODE : During CD mode, press RPT button to repeat a single track.
9. LUD/RDM BUTTON
LUD MODE: When reduce the volume to half level, press it to enhance the bass
effect.
RDM MODE: During CD mode, press RDM button for more than 2 seconds to play
all tracks in the random order, press it again to cancel the function.
10. MUTE BUTTON
Press it to eliminate the sound immediately. Press it again to release this mode and
recover the previous volume level.
11. BAND BUTTON
RADIO MODE: Press it to select your desired radio band and the word which band
is selected will be displayed on LCD.
CD MODE: Press it to change the mode to radio mode.
12. PWR BUTTON
Press power button to turn on or off the unit.
13. BUTTON
RADIO MODE: Change the mode to CDP mode.
CDP MODE: During CD playback, press it will stop play temporarily. Press it again
to return to normal playback.
14.
or BUTTON
A. In CD mode, press
/
button during playback to skip to next or back one track.
button for several seconds during playback
to fast forward or fast reverse. Releasing the button to stop fast playing.
B. In CD mode, press and hold
/
15. BUTTON
Press (EJECT) button to stop CD play and eject CD from the slot.
16. LED INDICATOR
Flashing when detachable panel is removed.
17. RESET BUTTON
Press it to rehabilitate the distorted program to zero.
2
INSTALLATION
DASH BOARD
METAL MOUNTING STRAP
HEX NUT
SPRING WASHER
PLAIN WASHER
PLAIN WASHER
CONSOLE
TAPPING SCREW
SLIDE BRACKET HOUSING
HEX BOLT
3
ELECTRIC CONNECTION
MAIN UNIT
ANTENNA CONNECTOR
RED
IGNITION
SWITCH (B+)
FUSE BOX
YELLOW
BLACK
FRONT RCA OUTPUT
CABLE (optional)
MEMORY (B+)
Rch RED
GROUND (B–)
Lch WHITE
BLUE
AUTO
ANTENNA
WHITE
GREY
FRONT
Rch SPK.
FRONT
Lch SPK.
+
–
+
–
WHITE/BLACK
GREY/BLACK
GREEN
VIOLET
REAR
Rch SPK.
REAR
Lch SPK.
+
–
+
–
GREEN/BLACK
VIOLET/BLACK
4
DISC NOTICE
Cleaning discs
Before playing, clean the disc with a clean, lint-free.
Flip the disc in the direction of the arrow.
NOTE:
Do not use so solvents such as benzine, thinners. Commercially available
cleaners or anti static spray damage the unit.
Insert a disc with the label surface down. Doing so may damage the unit.
Label
surface up
NOTE:
Do not try to insert another disc when one has been already inserted.
Doing so may damage the unit.
Handle the disc by its edge. And to keep the disc clean, do not touch the surface.
Do not stick paper or tape on the disc.
Do not expose the disc to direct sunlight or heat sources such as hot air ducts. Or leave
it in a car parked in direct sunlight where there can be a considerable rise in
temperature.
5
SPECIFICATIONS
Supply voltage
: 12V DC (11V-15V), test voltage 14.4V, negative ground
: Less than 5A
Current consumption
Audio signal output
characteristics
: (1) Frequency response 20 Hz-20 kHz
(2) S/N Radio
(3) Wow and Flutter
85 dB (JIS)
Below measurable limits
For 3 Bands
(Europe)
FM
For 2 Bands
(Europe)
FM
For 2 Bands
(U.S.A)
FM
Frequency Coverage
IF:
Sensitivity(S/N=30dB) : 20dBu
: 88 to 108MHz
10.7MHz
88 to 108MHz
10.7MHz
20dBu
88 to 108MHz
10.7MHz
20dBu
Stereo Separation
: >30dB
>30dB
>30dB
MW
MW
AM
Frequency Coverage
IF:
: 540 to 1600KHz
455KHz
540 to 1600KHz 530 to 1710KHz
455KHz
40dBu
455KHz
40dBu
Sensitivity(S/N=30dB) : 40dBu
LW(optional)
: 150 to 280KHz
: 455KHz
Frequency Coverage
IF
Sensitivity(S/N=30dB) : 45dBu
Note:
Specifications and design are subject to modification, without notice, due to
improvements in technology.
6
TROUBLE SHOOTING
Before going through the check list, check wiring connection. If any of the problems
persist after check list has been made, consult your nearest service dealer.
Symptom
No power.
Cause
Solution
The car ignition switch is
not on.
If the power supply is properly
connected to the car accessory
terminal,switch the ignition key
to “ACC“.
The fuse is blown.
Replace the fuse.
Disc cannot be Presence of disc inside the
Remove the disc in the player,
Then put a new one
loaded or
ejected.
player
Inserting the disc in reverse
direction.
Insert the compact disc with
the label facing upward.
The disc is extremely dirty or
defective
Clean the disc or try to play a
new one.
Temperature inside the car
is too high.
Cool off or until the ambient
temperature return to normal.
Condensation.
Leave the player off for an hour
then try again.
No sound.
Volume is in minimum.
Adjust volume to a desired level.
Check wiring connection.
Wiring is not properly
connected.
Sound skips.
The installation angle is
more than 30 degrees.
Adjust the installation angle less
than 30 degrees.
The disc is extremely dirty
or defective disc.
Clean the compact disc, then
try to play a new one.
The operation
keys do not
work.
The built-in microcomputer
is not operating properly
due to noise.
Press the RESET button.
Front panel is not properly
fixed into its place.
The radio does The antenna cable is not
Insert the antenna cable firmly.
notwork.
connected.
The signals are too weak.
Select a station manually.
88-C3220-04
7
|